Enterasys Networks CSX7000 manual Each mandatory connection uses xx bytes, Error closing file ’s’

USER’S GUIDE

Duplicate Calling Line ID <Calling line Id> detected for devices <device name> and <device name>

This message is logged at system initialization if any devices are found to share duplicate Calling line Ids, and have no other authentication method. This problem should be corrected by adding additional authentication method(s) to the necessary device(s).

Each mandatory connection uses xx bytes

There is not enough memory available to accommodate the system’s total capacity load. This informational message identifies how much memory is needed to add an additional mandatory connection.

Each optional connection uses xx bytes

There is not enough memory available to accommodate the system’s total capacity load. This informational message identifies how much memory is needed to add an additional optional connection.

ECP negotiation failed to converge

Verify compatible encryption parameters on each side of the link.

EDRV transmit error <error code>

An error was returned upon the software’s request to transmit a data frame. Contact your Distributor or Customer Support.

EDS-DES Board Absent

EDS-FEAL Board Absent

The encryption board is either physically not in the backplane, or the dip switches on the board are set incorrectly. Check for the board; verify the switch settings.

Error closing file ’s’

The WAN card initialization subsystem encountered an error while downloading a WAN card. The system could not close the download disk file indicated. Restart the system. If the error continues, Contact your Distributor or Customer Support.

Error closing file <file name>, slot <slot # >

Error closing password data file

If seen repeatedly, the above messages indicate a problem with your hard drive. Please contact your Distributor or Customer Support.

Error downloading bootstrap program to adapter #’x’

The WAN card initialization subsystem encountered an error on the indicated adapter while downloading the bootstrap program. Restart the system and review the configuration for the adapter. If the problem persists, the indicated adapter card may be faulty; contact your Distributor or Customer Support.

Error downloading operational software to adapter ’x’

The WAN card initialization subsystem encountered an error on the indicated adapter while downloading operational software. Restart the system and review the configuration for the adapter. If the problem persists, the indicated adapter card may be faulty and you should contact your Distributor or Customer Support.

500 CyberSWITCH