Enterasys Networks CSX7000, CSX5500, CSX6000 manual Banyan Vines Packet Detail Screen Bridged Packet

SYSTEM COMMANDS

Packet Capture Commands

Banyan Vines Packet Detail Screen					(Bridged Packet)
	Packet Number	Received at Time			Packet Length
	0021	0000022190 mSEC			0060
	Destination Address			Source Address
	FFFFFFFFFFFF			02608C9BED38
	EtherNet Type is 0BAD,		VINES IP
	Check Sum	Packet Length		Protocol Type
	D75D	0x001A			04, ARP
	Transport Control		Hop Count
	0			0
	Dest Network Dest SubNet		Source Network Source SubNet
	FFFFFFFF	FFFF		00000000	0x0000
	Packet Type	Network Number		Subnetwork Number
	Query	126697007			0x9183
		Hit Escape to EXIT Packet Details

IP Datagram Detail Screen													(Routed Datagram)
	Packet Number						Received at Time					Packet Length
			0009					0000003190 mSEC				0028
	Destination Address							Source Address
			001.001.001.001						001.001.001.001
	45	00	1C	00	01	00	00	00 40	01	76	DD 01 01 01 01		E.......@.v
	01	01	01	01	08	00	C3	ED 34	12	00	00		........4...
								Hit Escape to EXIT Packet Details

While the “pkt display” is displayed on your monitor, you can display the following help screen by entering “?”:

ESC	-	Exit Menu
‘u’	-	Previous Menu
‘d’	-	Next Menu
‘h’	-	Top of Packet List
‘e’	-	End of Packet List
Enter	-	Display Packet Details
‘t’	-	Time Menu
‘m’	-	Marks Packet as Start Time
Cursor-		to select an entry

Hit any key to exit Help

The time menu that is displayed when “t” is entered will enable you to toggle the time increment to be in either Sec (seconds), mSec (milliseconds), or tSec (deciseconds).

When the packet marking option is used, all packet times will be displayed relative to that marked packet. To mark a packet, use the arrow keys to move the cursor to the selected packet number, then press "m" The time for that packet will be set to 0. All packets received before that packet will have negative time values. All packets received after that marked packet will have progressively higher positive time values.

Central Site Remote Access Switch 611