Enterasys Networks CSX5500, CSX6000, CSX7000 manual None, 0.0

		CONFIGURING DEVICE LEVEL DATABASES
		On-node Device Entries
If your device requires an IP address, enter it now. Options are:
•	none	for Direct Host or WAN links that plan to use dynamic address allocation
•	0.0.0.0	for unnumbered WAN links

•IP address # for traditional numbered WAN links Enable or disable IP routing for this device.

If you want dial-out capabilities to this device, enable Make calls for IP data.

If you want to apply a predefined forwarding filter to this device, specify the filter name here. Refer to Forwarding Filters for more information.

11.To enter any needed IPX information for your device, select IPX from the Device Table Menu. The following screen will be displayed:

Device IPX Menu: (device =		"DAN")
1)	IPX Routing		DISABLED
2)	Make calls for IPX data		DISABLED
3)	IPXWAN Protocol		DISABLED
4)	IPX Routing Protocol		NONE
5)	IPX External WAN NetNum		NONE
6)	Spoofing Options
Select function from above		or	<RET> for previous menu:

a.Enable or disable IPX routing.

b.If you enable IPX routing and want dial-out capabilities to this device, enable the Make Calls feature.

c.If you enable IPX routing, you may enable or disable IPXWAN protocol.

d.If you enable IPX routing, select IPX Routing Protocol. Select a routing protocol of none, RIP/ SAP, or Triggered RIP/SAP. When you select Triggered RIP/SAP, you will need to identify the WAN peer type as either active or passive.

e.If you plan to use IPX over Frame Relay, and if you are also using a CSX200 or CSX400 on the other side of the Frame Relay connection, select IPX External WAN Net Num. Provide a unique number that you will also reflect on the CSX200 or CSX400 platform.

f.You may also select Spoofing Options. Make changes to default spoofing setup, if desired.

Refer to IPX Information for Devices and Configuration Elements for more information.

12.To enter any needed AppleTalk information for your device, select AppleTalk from the Device Table Menu. The following screen will be displayed:

Device AppleTalk Menu: (device = “DAN”)
1)	AppleTalk	Routing	DISABLED
2)	AppleTalk	Address	None
3)	Make calls for AppleTalk data		DISABLED
4)	AppleTalk	Routing Protocol	None
Select function		from above or <RET> for previous menu: 1

a.Press 1 at the above menu, then follow the on-screen instructions to enable AppleTalk routing for the device.

Central Site Remote Access Switch 189