Enterasys Networks CSX7000 manual LAN Adapter Command Timeout, LAN Adapter configuration conflict

SYSTEM MESSAGES

System Message Summary

LAN Adapter Command Timeout

The system expected a command from the LAN adapter or subsystem that it did not receive. Check for proper LAN adapter configuration and hardware installation. If it persists, report the event using the problem reporting form included in Getting Assistance.

LAN Adapter configuration conflict

There is a configuration conflict between the Ethernet resource that was installed and the Ethernet resource that was configured. Correct the configuration to match the installation.

LAN Adapter Fatal Error Reported

LAN Adapter hardware failure detected. If the problem persists, replace your LAN adapter.

LAN Adapter FIFO Data Underrun

The system expected data from the adapter that it did not receive, and the system will continue to operate. Check for proper LAN adapter configuration and hardware installation.

LAN Adapter FIFO not empty, status=<status value>

The LAN adapter did not enter the proper state after it was restarted. Check for proper LAN adapter configuration and hardware installation.

LAN Adapter HW upgrade may be required

Older versions of the Ethernet adapter may need to be updated to run Release 2.3 or greater. If the above message appears in your system log messages, you will need to remove your Ethernet adapter to determine if it is a version that needs to be updated. Refer to the “Notes and Warnings” section of the Release Notes for further instructions.

LAN Adapter HW upgrade required

Older versions of the Ethernet adapter may need to be updated to run Release 2.3 or greater. If the above message appears in your system log messages, you will need to upgrade your Ethernet adapter.

LAN Adapter LAN Controller error

The system detected an error with the LAN controller. The LAN adapter card may be faulty. Contact your Distributor or Customer Support.

LAN Adapter not configured

The system tried to access the bridging function when it was not configured. Most likely, the Ethernet resource was accidentally deleted. Correct the system configuration to reflect the proper Ethernet resource.

LAN Adapter out of receive buffers for LAN port <port #>

The LAN adapter is temporarily out of receive buffers for the indicated port. This condition should clear itself. If the condition persists, contact your Distributor or Customer Support.

LAN Adapter out of receive buffers for the WAN port

The LAN adapter is temporarily out of the buffers it uses to receive packets from the WAN port. This condition should clear itself. If the condition persists, contact your Distributor or Customer Support.

LAN Adapter port <port #> transmit error <error code>, check connection

The LAN adapter detected an error transmitting a frame on the indicated port. Check that the LAN is properly connected to the adapter and that the LAN is properly terminated.

Central Site Remote Access Switch 515