Enterasys Networks CSX7000, CSX5500, CSX6000 manual Removing Carbon Copy

REMOTE MANAGEMENT

Carbon Copy

1536Kb

1152Kb 2560Kb

4096Kb

768Kb

1384Kb

	1024Kb		2048Kb	3072Kb	4096Kb
Legend:			Remote Mgt (CC) or Local Console
		nnKb
			Only Local Console
		nnKb
		nnKb	Maximum Throughput Supported

Note: The above graph represents the guaranteed throughput without CRC errors. The actual throughput may be higher.

REMOVING CARBON COPY

To remove Carbon Copy from your system:

1.QUIT from the CyberSWITCH.

2.At the DOS prompt, type “dropcc”.

3.Reboot your CyberSWITCH.

NULL MODEM CONNECTION

To use Carbon Copy via a local NULL modem connection to make configuration changes, follow the steps listed below:

1.Insert Disk 1 from your Installation or Upgrade disk set labeled R2.3I13 or later, and reboot.

2.Carbon Copy will now be available via a NULL modem connection to the Serial Port.

3.Once the configuration changes have been made, remove the floppy and reboot your CyberSWITCH. Running the system with Disk 1 inserted is not recommended.

ADDING CARBON COPY

If you wish to restore remote management to your system, re-add Carbon Copy by following the steps below:

1.QUIT the CyberSWITCH.

2.At the DOS prompt, type “addcc”.

3.Reboot your CyberSWITCH.

Note: Carbon Copy is a registered trademark of Microcom Systems, Incorporated.

Central Site Remote Access Switch 575