Enterasys Networks CSX5500, CSX6000, CSX7000 manual Type, State

USER’S GUIDE

dnet

Required parameter. The destination network number.

dnode

Required parameter. The destination node Id.

timeout

Optional parameter. The number of seconds to wait for a reply message. The valid range is from 1 to 60 seconds. The default value is 10 seconds.

nnnn

Optional parameter. The data size to be included in the ping packet. The valid range for the data size is 5 to 586 octets. The default value is 100 octets.

An example atalk ping command could read as follows:

atalk ping 1.3 30 /d200

which would send a ping to node number 3 or network number 1, with a timeout value of 30 seconds, and the data size would be 200 octets.

atalk port

This command will display AppleTalk port information. A sample output screen is shown below:

Port 1
type: LAN	state: UP
address: 20.20	network range 20-21
flags: extended	phase-2	soft-seed
default zone: zone1
lan port: 1	physical address: 00409A001AB3
Port 2
type: WAN	state: UP
address: 30.30	network range 30-31
flags: extended	phase-2	soft-seed

default zone: zone1

Port 3

type: WAN UNNUMBERED state: UP

address: 20.20 (borrowed)

remote device: MAC4

The fields in this display are defined as follows:

type

The port type. Possible types are LAN, WAN, WAN UnNumbered.

Note that the WAN UnNumbered port information is not taken from the previously configured AppleTalk Routing port information, but is derived from the AppleTalk Routing static route configuration information.

state

The state of the port as it is in the process of coming up. Possible states include: listen - The port is listening to see if any other routers are out on the network. probing - The port is probing the network to see if its suggested AppleTalk address is unique, or if it is already in use.

588 CyberSWITCH