Enterasys Networks CSX7000, CSX5500, CSX6000 manual Security Rejection-Invalid Calling Line Id #

VERIFYING THE BASE SYSTEM

Remote Device Connectivity

fix> ConnId=<connect Id>

In - CONNECT Call Id=<call Id> Slot=<slot#> Port=<port #> Chans=<bearer channel map> Ces=<communication endpoint suf- fix> ConnId=<connect Id>

If the system reports these messages, then continue with the next step.

If the system does NOT report these messages, the remote device is not correctly connect- ing to the system. Check and verify the configuration of the remote device.

4.If the system displays the following message among the system messages:

Security Rejection-Invalid Calling Line Id - <#>

the network is indicating a calling line identifier that is not configured for any valid device in the system Device list. The number “#” indicates the actual number presented by the network.

5.For Remote Bridge Devices:

If the system displays the following messages among the system messages:

Security Rejection - Caller did not negotiate security Security Rejection - No Bridge Address given by caller Security Rejection - Unknown Calling Bridge Security Rejection - No Password given by caller Security Rejection - Invalid Password given Security Rejection - HDLC not supported by the caller

review the system configuration for the Device List. You can also refer to the System Messages chapter for the message meanings and the appropriate actions to be taken.

6.For IP Host Devices:

If the system displays the following messages among the system messages:

IP Call Dropped: ID_RSP was not received from remote

IP Call Dropped: XID was not received from remote IP Security Rejection - Digit string wrong length

IP Security Rejection - Invalid Security ID <Id string>

Review the system configuration for the Device List. You can also refer to the System Messages chapter for the message meanings and the appropriate actions to be taken. The first two messages indicate that the system did not receive the required protocol data. The second two messages indicate that the security configuration is incorrect.

7.For PPP Devices:

If the system displays any error or warning messages that begin with the following prefixes:

[PAP].....

[CHAP].....

[AUTH].....

There probably is an error in the remote device configuration. Review your remote device configuration. You can also refer to the System Messages chapter for the message meanings and the appropriate actions to be taken.

Central Site Remote Access Switch 425