VERIFYING THE BASE SYSTEM

Hardware Resources Operational?

Error mapping WAN adapter # into Host memory map

Type mismatch of configured & installed adapter #

Error initializing WAN card: #

Failure during static RAM test on adapter #

Error downloading operational software to adapter #

Error downloading bootstrap program to adapter #

To correct the problem, try the following:

a.Verify the resource type and adapter configuration settings as described in the Hardware Installation chapter.

b.Check the configuration for the WAN Adapter resource. The configuration must match the resource and its given slot number. Refer to the Configuring Resources and Lines chapter.

c.If these actions fail to correct this problem, check to see if the WAN adapter is properly installed in the CyberSWITCH. Refer to the Hardware Installation chapter.

CAUTION:

If at any time you need to remove the system cover, be sure to turn the system OFF and unplug it first.

Note: A Robbed Bit Signaling line will display a “Layer 1 up” message, but since an RBS resource does not have an ISDN layer two, a “Data link up” message will not be displayed.

LAN ADAPTER INITIALIZED?

1.Determine if the LAN adapter resource is operational by viewing the system messages. At the administration console type:

dr <return>

The dr command displays the current system messages. Look for these LAN adapter initialization messages among the system messages:

LAN Adapter Reset

LAN Adapter ROM version #.#.#

Note: Other messages may also be displayed with the LAN adapter initialization messages.

2.If these LAN adapter initialization messages are NOT displayed, and you see one of the following error messages, you may have a problem:

Invalid LAN Adapter identifier LAN Adapter Command Timeout

LAN Adapter FIFO not empty, status = # LAN Adapter LAN Controller error

LAN Adapter Response Timeout

MAC layer Bridge did not Initialize [IP] Initialization failure

Central Site Remote Access Switch 419

Page 419
Image 419
Enterasys Networks CSX7000, CSX5500, CSX6000 manual To correct the problem, try the following, LAN Adapter INITIALIZED?