Enterasys Networks CSX6000, CSX5500, CSX7000 manual IP SubNetwork number

USER’S GUIDE

b.Press 2 at the above menu to enter the device’s AppleTalk address. If the device is over an unnumbered link, enter 0.0. If the device is over a MAC dial-in port, you may either enter an address, or leave the value at “none”.

c.Press 3 at the above menu, then follow the on-screen instructions to configure whether or not dial out to this device is allowed for this device.

d.Press 4 at the above menu to specify an AppleTalk routing protocol the system should use with this device. The options are None or RTMP. Currently RTMP is only supported for devices who will be dialing into the CyberSWITCH via a MAC dial-in port.

Note: If you are configuring a device for AppleTalk Remote LAN, leave the above AppleTalk information at the default values (DISABLED, None, DISABLED, None).

Refer to AppleTalk Configuration Elements for more information.

13.To enter any needed bridge information for this device, select Bridge from the Device Table Menu. The following screen will be displayed:

Device Bridging: (device = "DAN")
1)	IP (Sub)Network number	NONE
2)	Bridging	ENABLED
3)	Make Calls for Bridge data	NONE
4)	IPX Remote LAN Network Number	NONE
5)	IPX Spoofing Options
6)	AppleTalk Network Number	NONE
Select function from above or <RET>		for previous menu:

You may enable or disable bridging for this device. If this device is to use a Remote LAN interface or Remote LAN port, enable bridging. If you want dial out capabilities to this device, enable Make calls for Bridge data.

For IP Remote LAN networks, you must explicitly configure the IP (Sub)Network number.

For IPX Remote LAN networks, you may configure the IPX external network number, or you may leave the value at NONE. The IPX Spoofing Options for IPX Remote LAN devices are not available at this time. For additional information, please refer to the Configuring IPX chapter, Remote LAN Devices.

For AppleTalk Remote LAN networks, you may configure the AppleTalk network number/ range (used on the Remote LAN for this device), or you may leave the value at NONE.

14.To enable per-device compression information, select Compression from the Device Table Menu. The following menu will then be displayed:

Device Compression Menu: (device = "DAN")

1)	Compression	ENABLED
2)	Starting PPP STAC-LZS Sequence Number	1

Select function from above or <RET> for previous menu:

a.If compression is not already enabled for this device, press 1 and follow the onscreen instructions to change the configuration to enabled.

b.If the remote device does not use 1 as the starting PPP STAC-LZS sequence number, press 2 to enter a new value for the starting sequence number.

190 CyberSWITCH