Enterasys Networks CSX6000, CSX5500, CSX7000 manual Rip/Sap

USER’S GUIDE

compare the incoming CLID with the value configured in the On-node Device Table. If the numbers are identical the connection will be established. Otherwise, the system will reject the incoming call.

When two remote devices share the same line (a single point-multipoint ISDN line), they can also configure the same CLIDs if they both also have some other type of authentication configured (for example, PAP, CHAP, or Bridge MAC Address Authentication).

Note: If a system is brought on line with a device that has a required CLID that is a duplicate of another device’s CLID, and no other type of authentication is used, a warning message is logged at initialization.So every attempt to connect the device thereafter will result in an error message being logged and the call being rejected.

IP INFORMATION CONFIGURATION ELEMENTS

IP ADDRESS

The device’s IP address, if any, on the WAN link connecting it to the CyberSWITCH. Options are: none (for Direct Host or WAN links that plan to use dynamic address allocation), 0.0.0.0 (for unnumbered WAN links), or an explicitly defined IP address.

The system must have a valid IP Network Interface defined for this IP address. When IP dial-out is used, this address is required by the IP routing system in order to map the IP address to the phone number to be dialed.

ENABLE/DISABLE IP ROUTING

You may enable or disable IP routing on a per-device basis.

ENABLE/DISABLE MAKE CALLS FOR IP DATA

This element must be enabled to allow IP dial-out to function. At least one Dial-Out phone number or X.121 address is required to dial out.

IPX INFORMATION CONFIGURATION ELEMENTS

IPX ROUTING

You may enable or disable IPX on a per-device basis.

MAKE CALLS FOR IPX DATA

Indicates whether the system should establish a WAN connection in order to forward IPX datagrams to this remote device. If enabled, at least one Dial-Out phone number or X.25 VC name is required.

IPXWAN PROTOCOL

Indicates that the remote device is an IPX router and that the IPXWAN protocol must immediately succeed IPXCP negotiations. Provides interoperability with Novell products.

IPX ROUTING PROTOCOL

Indicates the protocol the remote device will be using to communicate with the CSX system:

•none

•RIP/SAP

•triggered RIP/SAP

196 CyberSWITCH