Enterasys Networks CSX6000, CSX5500, CSX7000 manual Verifying System Options, Snmp

VERIFYING SYSTEM OPTIONS

OVERVIEW

This chapter describes the verification process for various system options. It includes the verification process for:

•SNMP

•Dial Out

•Call Detail Recording

•Compression

•Reserved Bandwidth

•DHCP Relay Agent and Proxy Client

•Semipermanent connections

•D Channel Callback

•Modem Callback

•Proxy ARP

To perform the verification procedures, WAN lines must be available and ready to use. LAN attachment components must also be available and ready to use.

During some of the procedures, we ask you to enter an administration console command. To enter these commands, you must have an active administration session. If you need instructions for starting an administration session, refer to Accessing the CyberSWITCH.

Note: At least one remote device is required to proceed with many of the verification procedures.

SNMP

1.To verify that the SNMP feature is operational, enter the snmp stats command at the administration console. If the statistics display appears, the SNMP subsystem should be fully operational.

2.If the following message is displayed, SNMP is not operational:

SNMP is not enabled

Try the following:

Check the configuration of the CyberSWITCH. In order for the SNMP Agent to become enabled, both the IP option and the SNMP Agent must be enabled in the CyberSWITCH configuration. (You may check the configuration by using the options and snmp commands in Manage Mode; however, you can only make changes to these items by using CFGEDIT).

3.Enter the dr command at the administrative console. If the following message appears, the IP subsystem has initialized successfully:

[IP] IP router is initialized successfully