Enterasys Networks CSX6000, CSX5500, CSX7000 manual Svc

CONFIGURING DEVICE LEVEL DATABASES

On-node Device Entries

If you select PVC, the list of available PVCs are displayed. The LCN of the selected PVC and the X.25 Access Name are stored in the Device Table to bind the device to a particular virtual circuit configuration:

Select the type		of the	Virtual	Circuit
1)	Permanent	Virtual Circuit (PVC)
2)	Switched Virtual		Circuit	(SVC)	[default 2]: 1

Current Permanent Virtual Circuits defined for X.25 Access #1, ’VMAX25’:

id Type		LCN	Protocol
-- ----		---- --------
1	PVC	1	RFC877
2	PVC	2	RFC877

Id of Virtual Circuit to associate with device "vma", or <RET> to cancel? 1

If you select SVC, you must enter the X.121 address of the remote DTE. You need the remote DTE address to make the X.25 call to the proper remote device.

Select the type		of the	Virtual	Circuit
1)	Permanent	Virtual Circuit (PVC)
2)	Switched Virtual		Circuit	(SVC)	[default 2]: 2

Enter the X.121 Address of the Remote DTE or press <RET> to cancel? 9987654321

8.For Digital Modem devices:

Begin by selecting Digital Modem from the Device Table Menu. The following menu will then be displayed:

Device MODEM Menu: (device = "DAN")
1)	Line Protocol	"PPP	(Point to Point Protocol)"
2)	Baud Rate	"Auto"
3)	Bearer Capabilities	"Speech"
4)	Dial Out Phone Number(s)	""
Select function from above or <RET>			for previous menu:

a.No change is necessary for Line Protocol. At this time, only PPP is available.

b.No change is necessary for Baud Rate. At this time, only Auto is available.

c.Select the line’s bearer capabilities.

d.Enter the phone number for this device.

Note: For detailed instructions on setting up your CyberSWITCH for Digital Modem usage, refer to Configuring Other Advanced Options.

Central Site Remote Access Switch 187