Enterasys Networks CSX6000, CSX5500, CSX7000 manual Displays system errors and system messages

USER’S GUIDE

Command		Use
ser <slot #> signal		displays current state of input signals for each serial line
		attached to card in specified slot. “0” indicates inactive;
		“1” indicates active.
session		displays the current active administration sessions
session kill <session id>		terminates the active session specified by the session id
snmp stats		displays current SNMP related statistics
sp		lists each semi-permanent device and associated status
start_ne		starts or restarts system software
status	(GUEST)	displays system errors and system messages
tcp conns		displays the current TCP connection status
tcp stats		displays the current system TCP statistics
telnet		puts you in the Telnet command mode
		see telnet mode commands for available commands
telnet <ip-address>[port # ]		begins a Telnet session for the indicated Telnet host
telnet mode commands:
close		closes the current Telnet connection to a target host
exit		closes the current Telnet session
open [target host][port #]		establishes a Telnet session with a target host
send [send parameter]		sends special Telnet control functions to the currently
		connected target host
set <name><value>		sets operating parameters for the current Telnet session
status		provides information about the current Telnet session
toggle		sets operating parameters for the current Telnet session
term		displays the terminal type.
term set <terminal type>		sets the terminal type
tftp get		invokes the TFTP GET command
tftp put		invokes the TFTP PUT command
tftp session		displays TFTP session statistics
tftp session kill <session id>		terminates the active TFTP session specified by the session
		id
tftp stats	(GUEST)	displays the current TFTP statistics
time[hours:minutes:seconds]		displays or changes current system time
trace [on/off]		enabled or disables call trace information reports
trace ipxwan [on/off]		enables or disables the IPXWAN tracing option

706 CyberSWITCH