Enterasys Networks CSX6000 Successfully Loaded Release X.Y Issue Z, TCP Connection to CSM Lost

USER’S GUIDE

Successfully Loaded Release <X.Y> Issue <Z>

The specified release of System software was successfully loaded into memory.

Switch could not recognize phone number nnnnnnn

The switch did not accept the phone number dialed as a complete number. Check the correctness of the phone number (including any leading digits such as 8 or 9).

System Clock Fault on Wan Adapter in Slot <slot #>

Indicates a TDM bus connection failure. Check to make sure that the TDM bus has been correctly connected.

TACACS authentication is not available. You must first ENABLE TACACS user level authentication. An attempt was made to configure the Terminal Server Security for TACACS and TACACS was not configured on the CyberSWITCH.

TCP Connection to CSM at <IP address> is DOWN; reason: <reason code>.

The TCP connection to the Connection Services Manager (CSM) has gone down. Contact your Distributor or Customer Support and provide them with the indicated reason code.

TCP Connection to CSM at <IP address> is UP.

A TCP connection exists between this device and the CSM at the indicated IP address.

TCP Connection to CSM Lost.

The TCP connection to the CSM has gone down.

TDM Clock Master changed TO (slot #, port#) FROM (slot # , port # )

The Clock Manager has dynamically adjusted the master clock source in response to an external line state change.

Temporarily unable to read flash file system due to flash reclaim in progress - try again later

The system is automatically performing a flash reclaim to reclaim space previously occupied by deleted files. Wait several seconds (up to a minute maximum) and try your file system command again.

Terminal Server Security connections disabled. Dropping call.

The Terminal Server Security is set to none and a terminal connection was requested. Check configuration. Most likely, the Default Async Protocol is set to terminal with no Terminal Server Security configured.

Terminal Server Security is currently using this database. You must change the Terminal Server Security setting first.

An attempt was made to disable a User Level Security Database when the terminal server was configured to use this database for terminal mode authentication.

[TFTP] Data buffer allocated successfully

All parts of the TFTP feature (both Server and Client) were successfully initialized.

Note: The following “[TFTP] Local error...” messages generated during client operations will be displayed on the console only and will not be logged to disk.

532 CyberSWITCH