Enterasys Networks CSX7000, CSX5500, CSX6000 manual Facility not subscribed Slot=slot # Port=port #

SYSTEM MESSAGES

System Message Summary

Facility not subscribed - Slot=<slot #> Port=<port #>

This probably indicates a SPID configuration error on the indicated line. The configuration should be corrected on the system or the switch.

Failed to allocate enough memory for XILINX load file

The WAN card initialization subsystem failed to allocate a buffer for use in downloading files. Restart the system. If the problem continues, contact your Distributor or Customer Support.

FAILED TO BOOT SYSTEM SOFTWARE

While attempting to load the System software, an error was detected. The system will automatically reset and attempt a reboot in an effort to correct the problem. If the system continues to fail, make note of the displayed messages, and contact your Distributor or Customer Support. A software update is likely needed.

FAILED TO FORMAT RFA

The Flash File System could not be formatted. The system will automatically reset and attempt a reboot in an effort to correct the problem. If the system continues to fail, make note of the displayed messages, and contact your Distributor or Customer Support. A software update is likely needed.

Failed to get a tone signaling session

An error has been detected in the R2 signaling procedure, and will typically result in a failed call. The error was due to unrecognizable or incorrect information. If problem persists, contact your Distributor or Customer Support.

FAILED TO INSTALL XMODEM FILESET INTO FLASH MEMORY

While writing a file into the Flash File System, an error was detected. The system will automatically reset and attempt a reboot in an effort to correct the problem. If the system continues to fail, make note of the displayed messages, and contact your Distributor or Customer Support. A software update is likely needed.

Failed to obtain Terminal info in smgr_proc_terminal_auth_sess 0

A session control block was not found for this authentication session. Contact your Distributor or Customer Support.

Failed to start a Terminal Auth session. Device + User level Security not enabled

A terminal mode connection was received and Device + User level security was not enabled. Verify correct security settings and default async protocol settings.

FAILED XMODEM INITIALIZATION

The UART controlling the Console Information Port (CIP) could not be initialized. The system will automatically reset and attempt a reboot in an effort to correct the problem. If the system continues to fail, make note of the displayed messages, and contact your Distributor or Customer Support. A software update is likely needed.

FAILED XMODEM SESSION

The X-Modem session did not successfully terminate. Likely causes include exhausting timeout limits and noisy lines. The system will automatically reset and attempt a reboot in an effort to correct the problem. If the system continues to fail, make note of the displayed messages, and contact your Distributor or Customer Support. A software update is likely needed.

Central Site Remote Access Switch 503