Enterasys Networks CSX6000, CSX5500 Bridging with PPP Bridge Devices Using BCP, PAP Password or

USER’S GUIDE

Bridging with PPP Bridge Devices (Using BCP)

To allow a PPP Bridge device to connect to the CyberSWITCH, you must have Bridging enabled. For each PPP Bridge device using this type of connection, you may need to enter a PAP Password or a CHAP Secret, and a Calling Line Id.

The following table identifies the configuration requirements for possible security options for PPP Bridge Devices.

Security Mode Configuration		On-node Device Table Configuration
			Data
Calling Line Id	PAP or CHAP	Calling Line Id		PAP Password or
	Security			CHAP Secret
Disabled	Enabled	Not Requested		Required
Enabled	Enabled	Optional per		Required
		device entry
Enabled	Disabled	Required		Optional

Note: If CHAP Security is enabled, and Outbound Authentication has not been disabled, a CHAP Secret must be entered for both the remote device and for the CyberSWITCH. Refer to the System Information for information regarding the System Secret. If Outbound Authentication has been disabled, a CHAP Secret is not required for the remote device.

IP Routing with PPP Bridge Devices (Using BCP)

To allow devices to connect to the CyberSWITCH using IP routing through a PPP Bridge device, you must configure a RLAN IP Network Interface. IP routing must also be enabled. For each PPP Bridge using this type of connection, you may need to enter the Device Name, a Calling Line Id, a PAP Password or a CHAP Secret, and an IP (Sub) Network Number.

202 CyberSWITCH