Enterasys Networks CSX6000, CSX5500, CSX7000 Unable to get Digital Modem resource to place call

USER’S GUIDE

Unable to get Digital Modem resource to place call

A Digital Modem dial-out call was attempted, and the system was unable to open a resource to place the call. Using the modem status command, check to ensure that there are usable modems available. If there are, and the problem persists, contact your Distributor or Customer Support.

Unable to Identify a remote device

A device that was not identified by any active security measures (for example, PAP or CHAP) was rejected.

Unable to Identify a remote device - <calling line id

A device that was not identified by any active security measures (for example, PAP or CHAP) was rejected and is identified by its Calling Line Id.

Unable to Identify a remote device - no CLID

A device that was not identified by any active security measures (for example, PAP or CHAP) was rejected and the caller did not present a Calling Line Id.

Unable to identify the frame type <CCB: xxxx>

The frame type (raw HDLC, RFC 1294, or PPP) can not be identified and therefore the connection has been terminated. “CCB: xxxx” is included for your Distributor or Customer Support. The most likely causes for the problem are: malfunction of the remote device, or a faulty line. Begin by checking the configuration of the remote device, and then rebooting the device. If this does not solve the problem, contact your Distributor. He/she will help you determine whether or not the line is faulty.

Unable to locate device entry in on-node database for terminal session

A device matching the login id entered at the user level security prompt was not found in the on- node database, and CSM was not configured.

Unable to open \config\devdb.nei file

Disregard this message if you have not yet added at least one device to the system’s on-node device table and saved the change. The configuration file, \config\devdb.nei, is created the first time the device table is saved. If the message continues, contact your Distributor or Customer Support.

Unable to open file DM56MDM.MOT for Modem revision verification on slot <slot #>

The CyberSWITCH could not find the DM56MDM.MOT file in the C:\SYSTEM directory. Contact your Distributor or Customer Support.

Unable to open Modem Upgrade file

There may be a problem with the modem revision file. Contact your Distributor or Customer Support.

Unable to register WAN Connection notification

RADIUS Accounting is enabled, but IP is not enabled (and IP routing is required). Check for proper configuration in CFGEDIT. If the problem persists, contact your Distributor or Customer Support.

Unable to restore original ISRs for Interrupt <interrupt #>

Check hardware jumpers and switches on the DM card and reinstall. Verify that the DM card is properly configured in CFGEDIT. If the problem persists, contact your Distributor or Customer Support.

538 CyberSWITCH