Enterasys Networks CSX6000, CSX5500, CSX7000 manual System is sending a call request to the network

USER’S GUIDE

Out - X25 Call Accept LCN <logical channel number>, <number of bytes> bytes The DTE is accepting an SVC call.

Out - X25 Call Request LCN <logical channel number>, <number of bytes> bytes The DTE is attempting to place an SVC call.

Out - X25 Clear Ind LCN <logical channel number>, <number of bytes> bytes

The DCE is clearing the X.25 Virtual circuit on the indicated LCN.

Out - X25 Clear Request LCN <logical channel number>, <number of bytes> bytes The DTE is clearing the SVC call on the indicated LCN.

Out - X25 CONNECTION REQUEST VcType=<virtual circuit type> ConnId=<connection Id> Access=<access index> RemDteAddr=<x121 address or protocol/route id>

The system is sending a call request to the network.

Out - X25 CONNECTION RESPONSE ConnId=<connection Id> Access=<access index>

The system is sending a connection to the network. This is sent in response to receiving a call indication.

Out - X25 DATA LCN <logical channel number>, <number of bytes> bytes

Data transfer.

Out - X25 DISCONNECT REQUEST ConnId=<connection Id> Access=<access index> Cause=<cause for disconnect>

The system is sending a disconnect to the network to terminate a call.

Out - X25 DISCONNECT RESPONSE ConnId=<connection Id> Access=<access index> The system has received a disconnect response from the network.

Out - X25 DTE Clear Conf LCN <logical channel number>, <number of bytes> bytes

The DTE is confirming that the virtual circuit on the indicated LCN has been cleared.

Out - X25 DTE Interrupt LCN <logical channel number>, <number of bytes> bytes

An interrupt packet has been sent to the DCE. Flow control procedures do not apply to interrupt packets.

Out - X25 DTE Intr Conf LCN <logical channel number>, <number of bytes> bytes The DTE is confirming the reception of an interrupt packet from the DCE.

Out - X25 DTE REJ LCN <logical channel number>, <number of bytes> bytes

The DTE has detected a packet sequence error.

Out - X25 DTE Reset Conf LCN <logical channel number>, <number of bytes> bytes The DTE is confirming that the virtual circuit has been reset.

Out - X25 DTE Restart Conf LCN <logical channel number>, <number of bytes> bytes The DTE is confirming that all virtual circuits have been reset.

Out - X25 DTE RNR LCN <logical channel number>, <number of bytes> bytes The DTE is not ready to receive more data packets.

556 CyberSWITCH