Enterasys Networks CSX5500, CSX6000, CSX7000 manual Tftp Commands, Tftp GET

SYSTEM COMMANDS

TFTP Commands

The following commands are used to display the terminal type currently in use or to set the terminal type.

term

Displays the terminal type name.

term set <terminal type>

Allows you to set the terminal type. You may set the terminal type to either vt100 or ANSI.

TFTP COMMANDS

The TFTP feature and its commands are only available when IP routing is enabled. The TFTP feature and file access are enabled by default when the system software is installed. Using the Manage Mode, configuration changes may be made that will limit file access. The following TFTP commands are available:

tftp get

Allows you to perform the “TFTP GET” operation locally from the console through the TFTP Client function. The following is an example display of a TFTP GET screen.

> TFTP GET

>IP Address of the Host containing the file (<RET> to abort)? 19.233.45.33

>Enter the name of the local file to write (including the full path)? (<RET> to abort)? \config\config.nei

>Enter the name of the remote file (including the full path) (<RET> for same as local)? <RET>

Enter the mode (BIN [binary] or ASC [ascii]) <RET> for ascii? bin

Receiving File... Please wait

File Transfer Complete...

tftp kill <session Id>

Allows you to kill a TFTP session. The session Id must be included in this command. To obtain the session Id, issue the tftp session command which displays the TFTP session information.

tftp put

Allows you to perform the TFTP PUT operation locally from the console through the TFTP Client function. The following is an example display of a TFTP PUT screen.

Central Site Remote Access Switch 621