Enterasys Networks CSX6000, CSX5500, CSX7000 manual Commands

SYSTEM COMMANDS

X.25 Commands

Alarm Type	Alarm Meaning
Loss of Signal (Red)	An all zero signal (or complete lack of signal).
Loss of Frame (Red)	A signal which does not match the configured
	framing mode (for example, ESF).
AIS (Blue)	An unframed all one signal.
RAI (Yellow)	A Remote Alarm Indication signal.

wan l1p error [display or clear] <slot #>

When display is used, this command displays the PRI layer 1 error counters. Refer to Layer 1 PRI Error Statistics for a list of available statistics and their definitions.

wan l1p loopback status <slot #>

Displays the current status of all loopbacks. (Refer to the following two “loop” commands.

wan l1p lcl_loop [disable or enable] <slot #>

Disables or enables a local loopback. When enabled, this loopback feeds the PRI adapters’s transmit signal back to the PRI adapters’s receive signal. It is useful in checking for problems in the PRI adapter itself.

wan l1p rem_loop [disable or enable] <slot #>

Disables or enables a remote loopback. When enabled, this loopback feeds the network’s transmit back to the network’s receive. This is useful for allowing switch personnel to test the entire connection from the switch to the PRI adapter and back.

wan l1p stats [display or clear] <slot #>

When display is used, this command displays the PRI layer 1 statistics. Two sets of statistics are provided: the specific PRI interface statistics, and layer 1 general statistics. Refer to WAN L1P Statistics for a list of available statistics and their definitions.

When clear is used, these statistics are cleared.

wan stats

Displays the current WAN statistics. Refer to WAN Statistics for a list of available statistics and their definitions.

X.25 COMMANDS

The following commands are used to display information concerning both the status and traffic statistics of a particular X.25 connection. A command is also available to allow the X.25 and LAPB packet tracing options to be enabled or disabled.

trace lapb [on/off]

Enables or disables the LAPB data link information packet tracing option. This feature displays up to 15 octets of the packet. To display the log file, issue the dr console command. This option is initially disabled.

Central Site Remote Access Switch 625