Enterasys Networks CSX7000, CSX5500 manual Enable Bridging and disable Make calls for bridge data

CONFIGURING IPX

IPX-Specific Information for Devices

3.Select On-node Device Entries from the device level databases menu.

4.Press 1 to add a device.

5.Enter the device’s name and press <RET>. You should provide ISDN and Authentication information first.

6.Select Bridging from the Device Table Menu. A menu similar to the following will be displayed:

Device	Bridging: (Device = "remote2")
1)	IP (Sub)Network Number		NONE
2)	Bridging		ENABLED
3)	Make calls for bridge data		DISABLED
4)	IPX Remote LAN Network	Number	NONE
5)	IPX Spoofing Options
6)	AppleTalk Network Number		NONE
Select	function from above or	<RET> for previous menu?

7.Enable Bridging and disable Make calls for bridge data.

8.Select IPX Remote LAN Network Number. Provide the external network number for the Remote LAN interface if desired. The default value, NONE, means the remote IPX external number will be the default IPX Remote LAN interface network number. Refer to page 329.

Note: The IPX Spoofing Options selection for Remote LAN devices is for a future release. Do not try to configure at this time.

USING MANAGE MODE COMMANDS

device add

Allows you to add a device entry to the Device List. You will be prompted for device information, including IPX information.

device change

Allows you to change information for a specific device entry. This will allow you, for example, to add IPX information to a previously configured device entry.

IPX CONFIGURATION ELEMENTS FOR DEVICES

IPX ROUTING

Indicates that the remote device is an IPX router and that the system should route IPX datagrams to this device. The system will forward IPX datagrams to this device based on IPX network layer information if this parameter is set to enabled. The system will not forward IPX datagrams to this device based on IPX network layer information if this parameter is set to disabled.

MAKE CALLS FOR IPX DATA

Indicates whether the CyberSWITCH should establish a WAN connection in order to forward IPX datagrams to this remote device. If the CyberSWITCH is properly configured for dial out, and if the remote device has IPX routing enabled and this Make Calls option enabled, then the CyberSWITCH will establish a WAN connection to this remote device in order to forward IPX datagrams.

Central Site Remote Access Switch 347