Enterasys Networks CSX7000 Appletalk Routing INITIALIZED?, Appletalk Routing OPERATIONAL?

USER’S GUIDE

constraints. We recommend this value be at least 10% more than what you predict to be needed (more than 10% with larger network topologies). To predict need, use the following formula:

(# configured static services) + (# SAP services)

a.Determine number of needed entries in service table:

•Issue the IPX service stats command to determine number of configured static services and SAP services;

•plug this data into previously-described formula.

b.Run CFGEDIT. From Options, select IPX Routing.

c.Select IPX SAP Table maximum number...

d.Increase the size of the table based upon your calculations.

APPLETALK ROUTING

APPLETALK ROUTING INITIALIZED?

1.Determine if AppleTalk routing has been initialized on the CyberSWITCH by viewing the system messages. To view the system messages, enter the following console command:

dr

2.Look for the following message among the system messages:

AppleTalk routing initialized successfully

3.For the AppleTalk port that has been configured, the following port initialization message should be displayed among the system messages:

AppleTalk successfully initialized on <port-type> with address <net.node>

Note: <port-type>is either LAN port 1, LAN port 2 or WAN. <net.node> is the AppleTalk address assigned to this port.

4.If you see these AppleTalk routing initialization messages, then the AppleTalk routing has initialized properly.

5.If these messages are NOT displayed, try the following:

Check the system configuration. Make sure that the AppleTalk feature is enabled for the system.

APPLETALK ROUTING OPERATIONAL?

To verify that AppleTalk routing is properly operational, a remote Macintosh must be operational and available to initiate WAN connections via a remote AppleTalk router device. Also, a local Macintosh device must be connected to the local LAN port on the CyberSWITCH.

452 CyberSWITCH