Enterasys Networks CSX7000 File Access Err, Formatting Flash Memory, Frame Relay event queue full

USER’S GUIDE

File Access Err

System unable to access file. Check for one of the following log error messages:

Error opening file <file name>

Error reading file <file name>, section = <section name> Error opening file <file name>, slot <slot #>

Read 0 bytes from file <file name> for WAN card in slot <slot #> Failure during read of file <file name> for WAN card in slot <slot #> Error closing file <file name>, slot <slot #>

Error closing password data file Error opening password data file Failure on closure of file <file name> Failure opening file <file name> Failure on file closure <file name> Failure on write of file <file name>

If you see any of these log messages repeatedly, there may be a problem with the file system. Contact your Distributor or Customer Support.

Formatting Flash Memory.....

The user has either requested the Flash to be formatted or a corrupted Flash File System was detected while attempting to save an upgrade/installation file set (transferred via X-Modem).

[FR_IETF] Authentication Failure of remote device NAME

[FR_IETF] Off-Node Authentication Failure of remote device NAME

The device database does not contain an entry for the device specified by NAME. Reconfigure either the PVC name or the device name so that they match.

[FR_IETF] detected PPP protocol from "NAME", shutting down PVC

FR_IETF has detected a configuration mismatch between the system and the remote device NAME. The administrator must change the PVC configuration on one of the devices.

Frame Relay event queue full

Indicates a lack of system resources to handle the level of traffic being experienced. Contact your Distributor or Customer Support.

Frame Relay PVC connection down: Slot=<slot number>, Port=<port number>

The Frame Relay PVC connection is down for the indicated slot and port number.

Frame Relay PVC connection up: Slot=<slot number>, Port=<port number>, DLCI=<DLCI index> The Frame Relay PVC connection is up for the indicated slot, port, and DLCI index.

FrBufFree: error <error code> during free

The indicated error occurred during an attempt to free a buffer to its memory pool. Contact your Distributor or Customer Support.

FrUtl: No registered device for DLCI <dlci index>

A frame was received on the PVC associated with the indicated DLCI, and no Frame Relay Service Device had (as yet) registered to use this PVC.

506 CyberSWITCH