Enterasys Networks CSX5500, CSX6000, CSX7000 manual Maximum Call Minutes PER Month

CONFIGURING CALL CONTROL

Call Restrictions

Two actions are available if this limit is exceeded. These actions are:

1.The call will not be allowed; a message will be displayed on the LCD, and written to the report log.

2.The call will be allowed; however, a warning will be displayed on the LCD, and written to the report log.

Note: Existing calls will not be disconnected when this limit is reached. Subsequent calls may not be allowed, but existing calls will be allowed to continue.

MAXIMUM CALL MINUTES PER MONTH

The maximum number of call minutes per month. The default value is 5520 call minutes per month. Call minutes will be calculated periodically while calls are active (not when a call is disconnected). Statistics will be kept to track the total number of call minutes made per month. This statistic will be written to the statistics log every half hour, and available through the ds command. The current value of this statistic will be displayed on the LCD, and will also be displayed on the monitor when the cr stats command is used.

Two actions are available if this limit is exceeded. These actions are:

1.The call will not be allowed; a message will displayed on the LCD, and be written to the report log.

2.The call will be allowed; however, a warning will be displayed on the LCD, and written to the report log.

Note: Existing calls will not be disconnected when this limit is reached. Subsequent calls may not be allowed, but existing calls will be allowed to continue.

MAXIMUM CALL LENGTH

The maximum amount of time (in minutes) that a call is allowed to be active. The default value is 240 minutes.

Note: The system checks for violation of configured maximum call length every five minutes. So, for example, if you set the maximum call length to one minute, there will be a five minute window around that one minute in which the system will check for a violation.

Two actions are available if a call exceeds this limit. These actions are:

1.The call is disconnected; a message will be displayed on the LCD, and written to the report log.

2.The call is continued; however, a warning will be displayed on the LCD, and written to the report log.

AUDIBLE ALARM STATUS

The audible alarm can be enabled or disabled. This alarm is used to signal you when a call restriction has been violated. The alarm is a series of beeps, that are repeated every 5 minutes while any call restriction is in violation.

Central Site Remote Access Switch 375