Enterasys Networks CSX6000, CSX5500, CSX7000 manual Calling phone number at data rate, device PPP

SYSTEM COMMANDS

Call Control Commands

Calling <phone number> at <data rate>, device PPP

The phone number will show what is sent to the switch. Any imbedded dashes will have been removed. The data rate that is used is displayed. If an invalid data rate is entered, the default of 56 Kbps will use used. Because dial out is only provided for PPP devices, the device type is always PPP.

One of the following messages will then be displayed:

Call initiated

This response indicates that a call peer request was performed. This does not always imply that a request reached the telephone switch.

Call attempt failed

This response indicates that the request could not be executed.

Note: The call peer <phone number> command will not work under the following conditions:

If PAP or CHAP is enabled and Outbound Authentication is disable, or, if the only security enabled is CLID. In either case, the CyberSWITCH will not be able to authenticate the remote peer. A message will appear in the log to indicate this. Use the call device <device name> command instead.

disc device <device name>

Disconnects all calls to the specified device. To obtain the device name, enter the Manage Mode and issue the device command. Note that the device name is case sensitive.

In response to the disc device command, one of the following responses will be displayed:

Disconnecting <device name>

Indicates that the disconnect process has been initiated for the indicated device.

No active connection to <device name>

Indicates that the device that you are attempting to disconnect has no active connection. The mc or the cs command can be used to view the active connections.

<device name> could not be found in the Device Table

Indicates that the device name could not be found in the table of configured device names.

More than one match for <device name> found in the Device Table

Displayed if you enter just part of a device name and that part could specify more than one device name. You will be prompted to enter the device name again, in a more specific manner. For example, if call device Sch is entered, and there is a device configured with the name Schultz, and a device configured with the name Schmidt, this message would be displayed. You would then need to enter at least call device Schu to successfully initiate a call to the device Schultz.

Re-enter the name, or <RET> to cancel

The device name must be re-entered.

Central Site Remote Access Switch 595