Enterasys Networks CSX6000, CSX5500, CSX7000 manual X25 facilities error, bad facility length

SYSTEM MESSAGES

System Message Summary

X25 facilities error, bad facility length

The facilities length is missing. Contact your Distributor or Customer Support.

X25 facilities error, invalid facilities length

The length of the facilities packet is invalid. Contact your Distributor or Customer Support.

X25 facilities error, invalid DTE address

The supplied address in a X.25 call packet was invalid. Verify that the local DTE address configuration matches the address supplied by the service provider.

X25 facilities error, facility not allowed

A facility was requested which is not enabled. Verify that the specific facility is enabled by both DTE’s and the service provider.

X25 facilities error, facility length too short

The length of the facilities packet is too short. Contact your Distributor or Customer Support.

X25 facilities error, invalid facilities parameter

A value was chosen for facility which is out of the acceptable range of values for that facility. The range of acceptable values for that facility should be verified at both DTE’s and by the service provider.

X25 facilities error, reverse charging not allowed

The reverse charging facility was selected by the DTE. Verify that reverse charging is enabled by both DTE’s and the service provider.

X25 facilities error, reverse charging not accepted

The reverse charging facility was selected by the DTE. Verify that reverse charging is enabled by both DTE’s and the service provider.

X25 facilities error, fast select not available

The fast select facility was selected by the DTE. Verify that fast select is enabled by both DTE’s and the service provider.

X25 facilities error, fast select not accepted

The fast select facility was selected by the DTE. Verify that fast select is enabled by both DTE’s and the service provider.

X25 facilities error, throughput negotiation not allowed

The DTE throughput class does not match the throughput class available at either the DCE or the remote DTE, and throughput negotiation is not enabled. You should enable throughput negotiation at both DTE’s. If this is not possible, or does not work, select the same throughput class at both DTE’s.

X25 facilities error, closed device group not allowed

The closed device group facility was selected by the DTE. Verify that the closed device group facility is enabled by both DTE’s and the service provider.

X25 facilities warning, reverse charging info not available

The service provider does provide reverse charging information. No action required.

Central Site Remote Access Switch 541