Enterasys Networks CSX5500, CSX6000 SSB Post 32 i960hdlc1 Failure, SSB Post 33 i960hdlc2 Failure

SYSTEM MESSAGES

System Message Summary

SSB: Post 32 i960hdlc_1 FAILURE

The i960 failed its 80532 test using the first HDLC controller. The boot process should continue; however, make note of the error message in the event of a future problem.

SSB: Post 33 i960hdlc_2 FAILURE

The i960 failed its 80532 test using the second HDLC controller. The boot process should continue; however, make note of the error message in the event of a future problem.

SSB: Post 34 i960hdlc_3 FAILURE

The i960 failed its 80532 test using the third HDLC controller. The boot process should continue; however, make note of the error message in the event of a future problem.

SSB: Post 35 i960hdlc_4 FAILURE

The i960 failed its 80532 test using the fourth HDLC controller. The boot process should continue; however, make note of the error message in the event of a future problem.

SSB: Post 36 i960isdn_1 FAILURE

SSB: Post 37 i960isdn_2 FAILURE

SSB: Post 38 i960isdn_3 FAILURE

SSB: Post 39 i960isdn_4 FAILURE

The i960 failed its 2086 test using the first (second, third or fourth) D-channel controller The boot process should continue; however, make note of the error message in the event of a future problem.

SSB: Timed out waiting for i960 to initialize for POSTSs

The i960 did not respond to an initialization request in a timely manner. This is a i960 failure. The boot process should continue; however, make note of the error message in the event of a future problem.

Starting Triggered RIP/SAP for <device>

This message indicates that triggered RIP/SAP has started for a device (either locally configured or one present in the WAN peer list). Triggered RIP/SAP has been configured as a routing protocol for this particular device.

Stream Ready rejected - MTU too small

The remote device will only accept the stream connection if the MTU is set to be > 1514. Check to make sure that the remote device and the CyberSWITCH MTU value is set to > 1514.

[STP] A BLAN Topology Change has been detected

The system has detected a topology change in the Spanning Tree environment.

[STP] A new Root Bridge has been detected

The system has detected a new root bridge for the Spanning Tree environment.

[STP] LAN Port <port # > is now a Designated Port

The indicated LAN port has become the designated port for the attached LAN.

[STP] LAN Port <port # > is now the Root Port

The indicated LAN port has become the root port for the system.

[STP] This Bridge is now the Root Bridge

The system has become the root bridge for the Spanning Tree environment.

Central Site Remote Access Switch 531