Enterasys Networks CSX7000, CSX5500 No Sites Connected, Not enough memory for Security module

SYSTEM MESSAGES

System Message Summary

No Sites Connected

Currently, no sites are connected to the system.

Not enough memory for Security module

Not enough system memory available to operate security module. Contact your Distributor or Customer Support.

No UA seen in response to SABMEs - Slot=<slot #> Port=<port # > Ces=<communication endpoint suffix> Layer 2 cannot be established between the system and the switch. This could be a TEI configuration mismatch between the system and the switch for the indicated line. Check the configuration of the system. If this is not the problem, call your carrier. The configuration of the switch may need correction, or the line may need to be manually restarted.

No VCB buffer available

Ran out of sending buffers for messages to Combinet. If this is a recurring problem, contact your Distributor or Customer Support.

Number of optional connections reduced from xx to yy due to memory limitations

This informational message identifies that there is not enough memory available to accommodate the system’s total capacity load for optional connections.

Number of required connections reduced from xx to yy due to memory limitations

This informational message identifies that there is not enough memory available to accommodate the system’s total capacity load for required connections.

Offnode server lookup of Dial Out User failed.

Off-node authentication was not successful. Most likely, the device attempting to authenticate was not configured. Check configuration.

OSW <OSWFileName>, found in the Flash File System. The OSW has not been updated from this file due to insufficient Flash File System space. Please delete unnecessary files from the system.

Delete unneeded files to free up Flash File System space, and reboot the system. DO NOT DELETE NEX.BIN, IOP.BIN, OR UPGRADE.BIN. The system will again attempt to install the compressed file set after the system is rebooted again.

Outgoing calls barred - Slot=<slot #> Port=<port #>

The system cannot place outgoing calls on the indicated line. The switch must be configured to handle circuit switched data calls. Contact your phone company and report the problem.

Out of accounting records

Contact your Distributor or Customer Support.

Out of CCBs, Port=<port # >, CallRef=<call reference # >

Contact your Distributor or Customer Support.

Out of LAN Adapter transmit command descriptors

The LAN adapter is temporarily out of buffers used to transmit frames on to the Ethernet. This condition should clear. If it persists, contact your Distributor or Customer Support.

Out of overflow RAM buffers

Contact your Distributor or Customer Support.

Central Site Remote Access Switch 521