Enterasys Networks CSX5500, CSX6000, CSX7000 Initial TDM Clock Master slot#, line#, Initializing

SYSTEM MESSAGES

System Message Summary

IePvcStatus: Received Status Report for unknown PVC # <dlci index>

The indicated unknown DLCI was indicated in a STATUS message received from the network. This DLCI number is entered in the “unknown DLCI” list and can be displayed via the FR LMI system console command.

Incoming call from <Device Name>, Slot=<slot #>, Port=<port #>, Chan=<channel # > Rejected by BW Reservation

A bandwidth reservation message. Indicates that a call has come in from the indicated device, on a line that is not in this device’s profile. The call will be disconnected. If you see this message often, check the remote device’s configuration to prevent wasted calls.

Initial TDM Clock Master: <slot#, line#>

The external line indicated has been selected as the master clock source.

Initializing...

Displays the current state of the system (initialization).

Installing File Set into Flash Memory

The file set, received via X-Modem, has successfully passed its verification tests and is now being written into the Flash File System.

Insufficient space for buffer pool creation

There is not enough system memory to proceed with the creation of the requested size buffer pool. Contact your Distributor or Customer Support.

Interrupt fault on WAN Adapter in Slot <slot #>

The interrupt jumper for the WAN Adapter in the specified slot is missing or misplaced.

Invalid caller number: <caller’s sites name> - <caller’s number>

The incoming call security feature is enabled and a call was received from an unknown remote site, therefore the call was disconnected. If the call was from a valid remote site, the device list must be updated to include the remote site's phone number.

Invalid Call_ID in HOST_CALL_CONNECTED

Invalid Call_ID in HOST_CALL_DISCONNECT

An error has been detected in the R2 or RBS signaling procedure, which typically results in a failed call. The error was due to unrecognizable or incorrect information. If problem persists, contact your Distributor or Customer Support.

Invalid CLLM received on Access <access index>

An invalid CLLM message was received on the indicated Frame Relay Access. The message had either missing elements or invalid contents.

Invalid LAN Adapter identifier

The system has detected invalid LAN adapter hardware. Check for proper LAN adapter configuration and hardware installation.

Invalid Password <password> given

The remote Combinet sent a password that did not match any device table entries. This most likely is due to a configuration error. Check the configuration, and change the password.

Central Site Remote Access Switch 507