SYSTEM COMMANDS

Viewing Operational Information

system prompt after the entire file has been displayed. If you are viewing the Release Notes, press the <escape> key to exit the release notes and continue with the installation.

If the file name is incorrect, the following message will be displayed:

Cannot find file "file name"

mc

Displays the Connection Monitor screen. This screen provides information on the remote sites to which the system is currently connected. The system updates the display as connections are added or removed.

To display the Connection Monitor screen, Telnet and the terminal emulator must both be set as the same terminal type. Use the term set command to do this.

Note: The mc command is also available if you are remotely connected to the CyberSWITCH by Telnet.

neif

This command will display the system interface table. This table provides information for each of the system’s physical interfaces, including interface name, interface type, slot and port number, and the operational status of each interface (up or down). This information can help to determine system problems by identifying those physical interfaces that are not operating as expected. Refer to the following example:

 

 

 

 

 

 

 

 

 

[System Name]> NEIF

 

 

 

 

 

 

id Name

Type

Slot

Port

Status

 

 

-- ----

----

----

----

------

 

 

1

Ethernet Port 1

Ethernet

3

1

up

 

 

2

Ethernet Port 2

Ethernet

3

2

down

 

 

3

BRI.LINE.1

BRI D-Channel

1

1

up

 

 

4

BRI.LINE.1

BRI D-Channel

1

2

up

 

 

5

V.35.LINE

V.35

2

1

down

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The definitions of the interface types and the associated status possibilities are as follows:

Ethernet

Each Ethernet port is considered an Ethernet interface. An Ethernet interface is “up” if the Ethernet port is capable of forwarding packets to/from the LAN. An Ethernet interface is “down” if the Ethernet port cannot be used to forward packets to/from the LAN.

Basic Rate (D-Channel)

Each Basic Rate line which contains at least one data link is considered a Basic Rate (D-Channel) interface. A Basic Rate (D-Channel) interface is “up” if at least one data link associated with the interface is “up.” A Basic Rate interface is “down” if none of the data links associated with the interface is “up.”

Basic Rate (Permanent)

Each Basic Rate line which is used by a dedicated access is considered a Basic Rate (Permanent) interface. A Basic Rate (Permanent) interface is “up” if the serial layer 1 is “up” for the line. The dedicated access does not have to be “up” for the interface to be considered “up”. A Basic Rate (Permanent) interface is considered to be down if the serial layer 1 is “down” for the line.

Central Site Remote Access Switch 579

Page 579
Image 579
Enterasys Networks CSX5500, CSX6000, CSX7000 manual Neif