Enterasys Networks CSX7000, CSX5500, CSX6000 Hardware Installation, PRE-INSTALLATION Requirements

HARDWARE INSTALLATION

OVERVIEW

This chapter provides a description of the hardware installation process. It includes:

•pre-installation requirements

•selecting slots for adapters

•setting switches

•inserting adapters into backplane

•connecting inter-board cables

Your distributor may have already completed this adapter installation. If not, follow this chapter’s specific instructions.

Only qualified personnel should install adapters into the

!CyberSWITCH.

CAUTION

Any time you remove the system module cover, unplug the power cord. Failure to do so may result in personal injury or equipment damage.

The CyberSWITCH is sensitive to static discharges. Use a grounding strap and observe all static precautions during this procedure. Failure to do so could result in damage to the CyberSWITCH.

PRE-INSTALLATION REQUIREMENTS

Before you begin the installation process, be sure to:

•Choose a suitable setup location

Make sure the location is dry, ventilated, dust free, static free, and free from corrosive chemicals

•Verify system power requirements

If applicable, make sure the line voltage select switch is set for the AC input power source you are going to use. The appropriate standard power cord is supplied with the system.

CAUTION:

When changing the line voltage select switch, make sure the AC power cord is unplugged.

•Verify cabling requirements

The cabling included with your shipment will depend on the country in which your system will operate. If additional cabling is needed other than what was shipped, contact your distributor.