Enterasys Networks CSX7000 PVC for Dlci dlci index not Active, PVC not allocated for dlci index

USER’S GUIDE

PVC for DLCI <dlci index> not ACTIVE

A frame was received on the PVC associated with the indicated DLCI which was not active. This is a temporary condition, and results from an asynchronous operation between the network and customer-premise equipment regarding the state of the individual PVCs. If this problem persists, contact your Distributor or Customer Support.

PVC not allocated for <dlci index>

The frame relay software received a frame from the network on PVC using the indicated DLCI which has not yet been configured. It is likely that there is a configuration mismatch between nodes in the network such that a node is transmitting data to the node logging this error via a valid but as yet unallocated PVC.

PVC rcv wait q already full

Indicates a lack of system resources to handle the level of traffic being experienced. Contact your Distributor or Customer Support.

RADIUS authentication is not available. You must first ENABLE RADIUS user level authentication. An attempt was made to configure the Terminal Server Security for RADIUS and RADIUS was not configured on the CyberSWITCH.

R2: Clearing chan <xx> due to abnormal forward reception

R2: Memory Slip Overflow Detected

R2: CLEAR_BACKWARD timed out on chan <xx>

R2: Transmit Overflow Detected

These messages may result in dropped calls. They indicate that the line may be extremely noisy, or that the modem installed in the system is not configured correctly (A-law vs. mu-law). Check configuration before proceeding.

R2: Illegal <event description>...

R2: Received unknown <primitive/message>...

R2: Unable to send host <specific request>...

These illegal events typically result in a failed call. Contact your Distributor or Customer Support.

R2: Task unable to allocate Scheduling Timer. Shutting down task.

R2: Unable to restart Scheduling Timer.

These are non-recoverable conditions in the R2 system. Most likely, an attempt was made to install R2 signaling on a system that does not support it. Contact your Distributor or Customer Support.

R2 not capable of Multichannel or Non-circuit calls

This illegal event typically results in a failed call. Contact your Distributor or Customer Support.

RBS: Channel <channel #> - Backing off of channel, GLARE detected.

An incoming and outgoing call occurred on the indicated channel at roughly the same time. The system discontinued the outgoing call in order to allow the incoming call to be established.

524 CyberSWITCH