Enterasys Networks CSX5500 Acct Warning code Timeout, Activation Failure- Session not active

SYSTEM MESSAGES

System Message Summary

[ACCT] Warning code: Timeout

This message is logged when there is no communication with the server. Either the accounting server is not up and running, or it cannot access the IP address. Verify the configuration of the server.

ACE authentication is not available. You must first ENABLE ACE user level authentication.

An attempt was made to configure the Terminal Server Security for ACE and ACE was not configured on the CyberSWITCH.

Activation Failure- Session NOT active

An error has been detected in the R2 signaling procedure, and will typically result in a failed call. The error was due to unrecognizable or incorrect information. If problem persists, contact your Distributor or Customer Support.

Adapter does not respond: adapter #’x’

The WAN card initialization subsystem encountered an error on the indicated adapter. Restart the system. If the problem persists, the indicated adapter card may be faulty and you should contact your Distributor or Customer Support.

Adapter #’x’ failed to initialize

The operational software on the indicated adapter card failed to signal that initialization was completed. Restart the system. If the problem persists, the indicated adapter card may be faulty and you should contact your Distributor or Customer Support.

Adapter #’x’ failed to respond from bootstrap

The WAN card initialization subsystem encountered an error on the indicated adapter while downloading the bootstrap program. Restart the system. If the problem persists, the indicated adapter card may be faulty and you should contact your Distributor or Customer Support.

Adapter failed to respond while programming: adapter 'x'

The WAN card initialization subsystem encountered an error on the indicated adapter while programming the hardware. Restart the system. If the problem persists, the indicated adapter card may be faulty and you should contact your Distributor or Customer Support.

Administrative Session using ACE does not support password change.

Passwords may only be changed via the ACE Server administrator initiation. During an administrative login, the user attempted to change password. ACE only supports password change initiated by ACE Server administrator.

AppleTalk routing initialized successfully.

This message is posted when the system AppleTalk routing feature has initialized successfully.

AppleTalk routing RTMP initialization error, AppleTalk disabled

AppleTalk is disabled because there is an initialization problem with the Routing Table Maintenance Protocol (RTMP). Contact your distributor or Customer Support.

AppleTalk routing ZIP initialization error, AppleTalk disabled

AppleTalk is disabled because there is an initialization problem with the Zone Information Protocol (ZIP). Contact your distributor or Customer Support.

AppleTalk successfully initialized on LAN port <port number> with address <AppleTalk address>. This message is posted when the specified AppleTalk LAN port has initialized successfully.

Central Site Remote Access Switch 483