Troubleshooting – Motor
Trouble | Probable Cause | Remedy | |
|
|
| |
| Motor brushes not sealed or lightly | Inspect/clean/replace brushes. | |
| sticking. |
| |
| Motor brake overheated from use of | See MAINTENANCE section. | |
| defective or wrong size blade or rapid |
| |
Brake does not stop | ON/OFF cycling. |
| |
blade within 10 | Arbor bolt loose. | Use a recommended blade. Let cool down. See | |
seconds. | |||
| Removing or Installing the Blade section. | ||
|
| ||
| Brushes cracked, damaged, etc. | Retighten. See Removing or Installing the Blade | |
|
| section. | |
| Other. | Replace brushes. | |
|
| Contact your Service Center. | |
|
|
| |
| Limit switch failure | Replace limit switch. | |
Motor does not start | Brush worn. | Replace brushes. See Maintenance section. | |
| Fuse blown or circuit breaker tripped | Verify there is electrical power at the outlet. | |
| on home panel. |
| |
|
|
| |
Brush spark when | Worn brush. | Replace brushes. See Maintenance section. | |
switch released. | Other. | Contact your Service Center. | |
| |||
|
|
|
Troubleshooting – Operation
Trouble
Blade hits table.
Angle of cut not accurate. Can not adjust miter.
Cutting arm wobbles.
Cutting arm will not fully raise, or blade guard won’t fully close.
Blade binds, jams, burns wood.
Saw vibrates or shakes.
Laser not aligned
Laser turns off
Probable Cause | Remedy |
|
|
Misalignment. | See the Setting Cutting Depth section in |
| Adjustments |
|
|
Miter table unlocked. | See the Miter Angle Adjustment section in |
| Operations |
Saw dust under table. | Vacuum or blow out dust. |
| Important: Wear eye protection. |
|
|
Loose pivot points. | Contact Service Center. |
|
|
Pivot spring not replaced properly | Contact Service Center. |
after service. |
|
Saw dust | Clean and lubricate moving parts. |
|
|
Improper operation. | See Operations section. |
Dull or warped blade. | Replace or sharpen blade. |
Improper blade size. | Replace with 12 in. diameter blade. |
Wood is moving during cut. | Use hold down clamp to secure workpiece to table. |
|
|
Saw blade not round / damaged / | Replace blade. |
loose. |
|
Arbor bolt loose. | Tighten arbor bolt. |
|
|
Contact Service Center. | |
|
|
Laser turns off after 20 minutes to | Reset laser switch on trigger handle (turn off, after |
prevent heat buildup. | 2 seconds turn on again). |
|
|
30