Mounting Rails
Hardware: Front Rail, Rear Rail, (4) M8x16 Socket Head Cap Screws, (4) M8 Flat Washers,
(4)Lock Washers, (2)
Tools: 6mm hex wrench, two 13mm wrenches Refer to Figures 4 and 5.
1.Mount the front rail (A) to the underside of the table (B) with two socket head cap screws (C), two lock washers (D), and two M8 flat washers
(E).
2.Insert a
3.Mount the rear rail (L) to the backside of the table (M) with two socket head cap screws (N), two lock washers (O) and two M8 flat washers (P).
4.Insert a
Mounting Left Extension Wing with Miter Slot
Note: If you have a sliding table, skip this section and proceed to the Mounting Sliding Table section.
Hardware: Left Extension Wing, (4) M10x90 Socket Head Cap Screws, (4) M10 Lock Washer,
(4) Flat Washers
Tools: Cross Point Screw Driver, Straight Edge, Rubber Mallet, 8mm Hex Wrench
Referring to Figure 6:
1.Remove the arbor pulley guard (A). This is only needed for the sliding table.
2.Attach left extension wing (B) to the table with four socket head cap screws, four lock washers and four flat washers (C). Snug but do not tighten.
3.Slide extension wing toward the front edge of the saw table until two faces are flush.
4.Place a straight edge across the table and left extension wing. Align the extension wing the same height as the saw table and tighten socket head cap screws.
Note: Use a rubber mallet to align wing with table.
11
Figure 4
Figure 5
Figure 6
