Assembly
Unpacking and Clean-Up
Do not connect the table saw to the power source until assembly has been completed! Failure to comply may cause serious injury!
• Tool: 12mm Wrench
1.Remove all contents from the shipping container. Do not discard any shipping material until the saw is set up and running satisfactorily.
2.Carefully move saw to its final location.
3.Remove the dust baffle from the cabinet (refer to page 30, Items 11 and 12).
4.Remove the hex cap screws from skid bottom.
5.With help from another person lift the saw off the skid and into position.
6.Install the dust baffle in the cabinet.
Installation Requirements
The final location for the saw must be level, dry, well lighted, and have enough room to allow movement around the saw with long workpieces.
Right Extension Wing Assembly
Hardware: (3) M10x30 Hex Cap Screws, (3) M10 Lock Washers, (3) M10 Flat Washers & (1) Extension Wing
Tools: 17mm Wrench, Straight Edge Refer to Figures 1 and 2:
1.Attach right extension wing (A) to the table (B) with three each hex cap screws (C), lock washers (D) and flat washers (E). Snug but do not tighten.
2.Slide extension wing toward the front edge of the saw table until two faces are flush.
3.Using a straight edge (F, Fig. 2), align the extension wings to the saw table and tighten the hex cap screws.
Handwheel Assembly
Hardware: (2) Handles, (2) Handwheels & (2) Lock Knobs
Tool: 14mm Wrench Referring to Figure 3:
1.Slide the handwheel (A) onto the shaft (B); make sure that the spring pin on the shaft lines up with the slot on the handwheel.
Figure 1
Figure 2
Figure 3
2.Thread center lock knobs (C) into the shaft (B).
Note: The knobs will allow you to lock the blade into a certain height, or angle.
3.Thread the handles (D) into the handwheels and tighten with a wrench.
10
