Maintenance
General Maintenance
Cabinet and Motor: Keep the inside of the cabinet clear of sawdust and wood chips. Vacuum out the inside of the cabinet and blow out the inside with an air hose. Make sure the motor fan and fan cover are also kept clear of sawdust.
Worm Shafts and Trunnions: Use a wire brush and a cleaner/degreaser to clean worm shaft, and trunnions. Apply white lithium grease or powdered graphite to lubricate worm shaft, and trunnions.
Sliding Table: After a days use push the sliding table all of the way forward and wipe out any sawdust that may have made it past the wipers. The important part of the bearing sliders is the mating grooves (A, Fig. 54) that the bearings ride along.
Pull the sliding table all of the way forward and wipe out any sawdust that may have made it past the wipers. The important part of the bearing sliders is the mating grooves (A, Fig. 55) that the bearings ride along.
Add a small amount or lightweight oil to the bearing grooves, if necessary and run the sliding table back and forth to work the oil into the bearings. Wipe off any excess oil.
Table Top: Remove rust from the tabletop with
Blades and Accessories |
|
10” x 40T carbide | 709733 |
10” x 60T carbide | 709734 |
Feather board | 709721 |
708295 | |
Tenoning Jig Adaptor Plate | 708295SS |
Tenoning Jig Kit* | 708295SSK |
XACTA Lift | 708124 |
Outfeed Rollers | 708150PK |
Universal Mobile Base | 708119 |
*Consists of
27
Figure 54
Figure 55
