Squaring Work Table with Blade
1.Place the table in horizontal position with “0” on the scale (Figure 11).
2.Place a machinist’s square on the table and against the blade as shown.
3.If the square is not flush against the blade, loosen the screw below the table (Figure 11) with a 26mm wrench (provided).
4.Tilt the table as needed until the square is flush with blade. Retighten the screw.
5.Make sure the pointer is set at “0” on the scale. If it needs slight adjustment, loosen the screw and shift the pointer until it aligns with “0”.
Auxiliary Table
1.After the main work table has been set perpendicular to the blade, use a straight edge to confirm that the auxiliary table is level with the main table, as shown in Figure 12. If the auxiliary table is not level with the main table, make adjustments as follows.
2.To tilt the auxiliary table left or right, loosen the screws (A, Figure 12) and turn one of the stops (B, Figure 12) as needed. Re- tighten screws (A, Figure 12) securely after adjustment.
3.To adjust the table front to back, loosen screws (C, Figure 12).
Replacing Drive Belts
(See Figure 13)
1.Disconnect machine from power source.
2.To remove the motor drive belt, loosen the four screws at the base of the motor. Lift up on the motor to slacken and remove the belt.
3.To remove the air compressor drive belt, loosen the four hex nuts on the base of the air compressor and slide the compressor in the direction of the motor. After installing a new belt, slide the compressor away from the motor to tension the belt, and
4.To remove the gearbox drive belt, loosen the hex nuts on the base of the lower variator, and slide the lower variator upward to slacken and remove the belt.
5.To remove the variator belt, loosen the four hex nuts on the variator and push the variator upward to slacken the belt.
Figure 11
Figure 12
Figure 13
14
