as shown in Figure 10. Finger tighten only.

5.Install three 1/4-20 x 1-1/2 hex cap screws, three 1/4 flat washers, and three 1/4 nuts into the holes in the rear edge of extension table as shown in Figure 11. Finger-tighten only.

6.Re-check the table for alignment, make further adjustments if necessary, then tighten all screws and nuts.

7.Mount the two legs to the inside corners of the extension table as shown in Figure 12. Secure with the eight screws provided.

Note: If you are using a mobile base under your saw, you may need to shift the placement of the legs so they rest properly upon the shelves of the base.

8. Adjust the footpads on the legs counterclockwise until they reach the floor, then tighten the nut.

Guide Tube

Referring to Figure 13:

The guide tube (A) is placed on top of the front rail

(B)and is mounted with the scale facing toward the operator.

1.Align the holes in the bottom of the guide tube with the holes in the front rail. When properly positioned the guide tube should extend beyond the front rail about 6" in both directions.

2.Fasten the guide tube (A) to the rail (B) from beneath, with seven 1/4-20 x 3/4 hex head screws (B), seven 1/4" lock washers (F) and seven 1/4" flat washers (G). Finger tighten only.

3.Tighten all screws with a 7/16" wrench.

Figure 11

Figure 12

Figure 13

10

Page 10
Image 10
Jet Tools XACTA owner manual Guide Tube