"Fast Heat Up" function
Afteracookingfunctionhasbeenselectedandthetemperaturehas been adjusted, the cavity will gradually heat up until the selected temperature is reached. This will take from 10 to 15 minutes, depending on selected function and temperature.
Ifitisnecessarytoreachtherequiredtemperatureinashortertime, the "Fast Heat Up" Function can be used.
1)Switch the oven on by pressing button .
2)Settherequiredcookingfunctionandtemperatureasexplained in the previous pages.
3) Set the temperature by pressing button “ “ or ““. The temperature will appear on the display.
4)Press button Fast heat up . The temperature display will show "FHU" (Fig. 18).
5)press button Oven function and the symbol “°” will flash for approximately 10 seconds. Now it is possible to select the
required temperature by pressing button “ “ or ““.
4)When the required temperature is reached, an acoustic alarm will sound for a short time, and the temperature display will revert to the set temperature.
Thisfunctioncanbeusedwithanycookingfunctionortemperature.
Demo mode
This mode is intended to be used in the shops to demonstrate the oven functionality without any power consumption except the oven lamp.To activate this function the appliance should be in
—Press button Fast heat up and “ “ for approximately 2 seconds (Fig. 19). An acoustic alarm will sound for a short time.
—Press button and the “id” indication will appear in the display.
All oven functions can be selected.
The thermometer symbol will flash as “id” indication and number digits.
Follow the above described procedure to dis- able the demo mode.
Error code
The electronic programmer does a continuous diagnostic check of the system. If some parameters are not correct, the control unit will stop the activated functions and it will show on the display the corresponding error code.
For further details, refer to chapter "Something not work- ing“ on page 22.
"Beep" Mode
You can choose to make The Electronic Control beep each time that a control is touched.
To enable this function, the oven must be off.
1.Press controls Oven functions and ““ at the same time for about 3 seconds. The Electronic Control beeps once
To disable the "Beep" Function:
1.If the oven is on, press button to switch it off.
2.Press controls Oven functions and ““ at the same time for about 3 seconds. The Electronic Control beeps once
Fig. 18
Fig. 19
14