John Lewis JLDWW 1203 Something Not Working, a flashing fault code appears, Symptom, Solutions

Something Not Working

If the dishwasher is not working correctly, please carry out the following checks, before contacting your local Service Force agent.

IMPORTANT: If the END light flashes and an alarm code is displayed, switch the machine off and call the telephone number given below.

IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.

...a flashing fault code appears

If one of the following fault codes is displayed in the multi-display during operation:

–Fault codeÅ 10 (Problems with water inlet),

–Fault codeÅ 20 (Problems with water drainage), please have a look at the following table.

When the fault is remedied, press the button for the cycle that has started. The cycle will continue.

With other fault codes (“Å ” followed by a number):

–Cancel the dishwashing cycle.

–Switch the appliance off and on again.

–Re-set the dishwashing cycle.

If the fault is displayed again, please contact your local Serv- ice Force Centre and inform them of the fault code.

Symptom	Possible cause	Solutions
	The water tap is blocked or furred with	Clean the water tap.
	limescale.
	The water tap is turned off.	Turn the water tap on.
	The filter (where present) in the
The cycle indicator for the selected	threaded hose fitting at the water inlet	Clean the filter in the threaded hose fitting.
dishwashing cycle is flashing:	valve is blocked.
fault code Å 10 is displayed in the mul-
		Cancel the dishwashing cycle (see chapter:
ti-display:
	Filters in the base of the dishwasher	Starting a washing programme), clean fil-
(Problems with water inlet)
	compartment are blocked.	ters (see chapter: Cleaning the filters),
		then start the washing programme again.
	The water inlet hose
	has not been correctly laid or it is bent	Check the water inlet hose connection.
	or squashed.
The cycle indicator for the selected	The sink spigot is blocked.	Clean out the sink spigot.
dishwashing cycle is flashing,
	The water drain hose
fault code Å 20 is displayed in the mul-		Check the water drain hose connection.
ti-display.	has not been correctly laid or it is bent
	or squashed.
(Problems with water drainage)
		First shut off the water tap, then switch off
Fault code Å 30 is displayed in the mul-	The anti-flood system has been trig-	the appliance and contact our extended
ti-display.	gered.	warranty administrators, refer to Repairs -
		After Sales Service on page 29.

Once the checks have been carried out, close the door and press the button of the programme that was running before the in- tervention of the alarm.The programme will continue from the point at which it was interrupted. If the fault code reappears or if another fault code not described above appears contact our extended warranty administrators, refer to Repairs - After Sales Service on page 29.

1 Attention: once having verified which kind of mal- function has occurred, before carrying out the checks the appliance MUST be switched off.

27