John Lewis JLDWW 1203 instruction manual Levelling the Dishwasher, Proceed as follows

If the dishwasher is later used as a free-standing ap- pliance, the work surface supplied with it must be re- mounted.

Be sure that once the appliance has been installed, it is easily accessible for the service engineer in the event that a repair is required.

Proceed as follows:

1.Unscrew the screws from the elbows at the rear (1).

2.Push the appliance’s worktop backwards about 1 cm (2).

3.Lift the worktop at the front (3) and remove it. Insert the machine after adjusting

height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed. During all operations that involve accessibility to internal components the dishwasher has to be unplugged.

1

1 If the dishwasher is installed directly next to a cook- er, a heat-insulating, non-flammable panel (laminated with aluminium foil on the side next to the cooker) must be fitted flush with the top edge of the work surface.

1

3The plinth on free-standing appliances is not adjusta- ble.

Levelling the Dishwasher

•The dishwasher must be installed on a firm floor and ad- justed to ensure that it is stable and level in all directions.

•To overcome irregularities in the floor and to match the height of the appliance to that of surrounding units, ex- tend the threaded feet using a screwdriver.

•The drain hose, inlet hose and mains cable must be laid so that they are able to move freely within the plinth area, and so that they are not kinked or crushed when the dish- washer is in position.

Good levelling is essential for correct closure and sealing of the door.

When the appliance is correctly levelled, the door will not catch on either side of the cabinet.

If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.

9