Fault code and malfunction
• appears in the digital display
Anti-flood device is activated
Possible cause and solution
•Close the water tap and contact our extended warranty administrators, refer to
Malfunction
The programme does not start
Possible cause and solution
•The dishwasher door has not been properly closed. Close the door.
•The main plug is not plugged in. Insert the main plug.
•The fuse has blown out in the household fuse box. Replace the fuse.
•Delay start has been set.
If dishes are to be washed immediately, cancel the delay start.
Once these checks have been carried out switch on the appliance.
The programme will continue from the point at which it was interrupted.
If the malfunction/fault code reappears or if other fault codes not described in the charts appear, please contact our extended
warranty administrators, refer to section ''Repairs - After Sales Service''.
The wash results are not satisfactory
The dishes are not clean
The dishes are wet and dull
There are streaks, milky spots or a bluish coating on glasses and dishes
•The wrong programme has been selected.
•The dishes are arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded.
•The spray arms do not rotate freely due to incorrect arrangement of the load.
•The filters in the base of the washing compartment are dirty or incorrectly positioned.
•Too little or no detergent has been used.
•Where there are limescales deposits on the dishes; the salt container is empty or the incorrect level of the water softener has been set.
•The drain hose connection is not correct.
•The salt container cap is not properly closed.
•Rinse aid was not used.
•The rinse aid dispenser is empty.
•Decrease rinse aid dosage.
26