Remove the machine’s worktop by unscrewing the two rear retaining screws (1), pull the worktop from the back of the machine
(2)and slide out the front slots, lifting the worktop (3).
Insert the machine after adjusting the levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.
During all operations that involve accessibility to internal components the dishwasher has to be unplugged.
Be sure that once the appliance has been installed, it is easily accessible for the service engineer in the event that a repair is required. If the dishwasher is later used as a free- standing appliance, the original worktop must be
The plinth on
Levelling
Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on either side of the cabinet. If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.
Water connections
Water supply connections
This dishwasher may be fed with either hot (max. 60°) or cold water. Nevertheless we advise you use a cold water supply.
A hot water supply is not always efficient with heavily soiled crockery as it shortens the washing programmes a lot.
For making the connection itself, the coupling nut fitted to the machine’s supply hose is designed to screw onto a 3/4" gas thread spout or to a purpose made
29