TABLE 1: Indoor Parts
|
| Flare nut 1/4" for small | |
Remote Control | 1 | line on all size units | |
except 30K which | |||
|
| ||
|
| uses 5/8". | |
|
| Cable routing guide | |
Batteries (AAA) | 2 | with mounting | |
hardware (18 - 24 kBtu | |||
|
| ||
|
| systems only) | |
Wall mounting bracket | 09, 12 & 18 kBtu (5) | Installation Manual | |
screws | 24K kBtu (10) | ||
| |||
Foam tube insulation |
| User’s Information | |
(for condensate line | 1 | ||
Manual | |||
attached to indoor unit) |
| ||
|
|
1
1
1
1
ASSEMBLED OUTDOOR UNIT
The assembled outdoor unit will include the following items which are located with the unit:
TABLE 2: Outdoor Parts
Auxiliary drain hole plugs |
| 1 - 3 |
(heat pump only) |
| |
|
| |
|
|
|
Drain plug |
| 1 |
(heat pump only) |
| |
|
| |
|
|
|
SECTION IV: REQUIRED INSTALLATION TOOLS (NOT SUPPLIED)
1.Gauge manifold
2.Electronic balance for refrigerant charging
3.Phillips head screwdriver
4.Knife or wire stripper
5.Carpenters level
6.Hammer
7.Drill
8.Tube cutter
9.Tube flaring tool
10.Torque wrench
11.Adjustable wrench
12.Reamer (for
13.Vacuum pump (For R410A)
14.Gas leakage detector
2.Select a location where the condensate can be easily drained out.
3.Install in a location where there is enough space to access the unit for routine maintenance (air filter can be removed for cleaning or replacement).
4.Install where airflow is not blocked.
5.Install in a location for optimized cold or warm air distribution.
6.Install in a location that's not exposed to direct sunlight.
7.Install in a location that's at least 3 ft away from a TV and radio to avoid possible interferences with the operation of the air condi- tioner/heat pump.
8.Install in a location that's at least 3 feet away from fluorescent and incandescent lights to avoid interference with the remote control.
| A |
| |
D |
| C | |
|
| ||
| B |
| |
Reference | Location | Required | |
Clearance | |||
|
| ||
A | Clearance between unit and ceiling | 6 inches | |
B | Clearance between unit and floor | 6 feet | |
C / D | Clearance to the right and left of the unit | 6 inches |
FIGURE 1: Indoor Clearances
SECTION V: SELECTING THE
INSTALLATION LOCATION
INDOOR UNIT (SEE FIGURE 2 FOR INSTALLATION DIMENSIONS)
1.Install the unit securely in a place that can bear the weight and vibration of the unit.
REMOTE CONTROL
1.Keep the remote control where it is convenient to operate and eas- ily visible.
2.Keep the remote control away from children.
3.When using the I FEEL feature, select a location for the remote control that's about 4 ft. above the floor.
Johnson Controls Unitary Products | 3 |