Jotul F 3 CB WOODSTOVE CLEARANCES, Stove Clearances, Unprotected Surfaces, Protected Surfaces

F 3 CB WOODSTOVE CLEARANCES*

STOVE CLEARANCES	UNPROTECTED SURFACES			PROTECTED SURFACES
TOP VENT/VERTICAL				per NFPA 211 or CAN/CSA-B365-M
	SIDE	REAR	CORNER	SIDE	REAR	CORNER
Rear heatshield with	24"	25"	18"	10"	14"	10"
Single wall pipe	610 mm	635 mm	460 mm	255 mm	355 mm	255 mm
Rear heatshield with	18"	10"	14"	6"	6"	6"
Double wall pipe or shields	460 mm	255 mm	355 mm	150 mm	150 mm	150 mm
STOVE CLEARANCES	UNPROTECTED SURFACES			PROTECTED SURFACES
REARVENT/HORIZONTAL				per NFPA 211 or CAN/CSA-B365-M
	SIDE	REAR	CORNER	SIDE	REAR	CORNER
Rear heatshield with	24”	25”	20”	10”	25”	18”
Single wall pipe	610 mm	635 mm	510 mm	255 mm	635 mm	460 mm
Rear heatshield with	18”	14”	17”	6”	6”	6”
Double wall pipe or shields	460 mm	355 mm	430 mm	150 mm	150 mm	150 mm
CONNECTOR	UNPROTECTED SURFACE			PROTECTED SURFACE
CLEARANCES				per NFPA 211 or CAN/CSA-B365-M
Single wall pipe-vertical installations		18" (460mm)			6" (150mm)
Double wall pipe-vertical installations		pipe mfgr. listing			pipe mfgr. listing
Single wall pipe-horizontal installations		18” (460mm)			9” (230mm)
Double wall pipe-horizontal installations		pipe mfgr. listing			pipe mfgr. listing

VERY IMPORTANT:

Top Vent - Vertical: assumes the connector pipe runs from the top of the stove and travels vertically. If top vented to a horizontal run, the stove position is dictated by the connector pipe clearances.

Rear Vent - Horizontal: assumes the connector pipe extends from the rear of the stove and travels horizontally to the chimney. If rear vented to a vertical run, the stove position is dictated by the connector pipe clearances.

Dimensions in Inches represent U.S. requirements. Dimensions in Millimeters represent Canadian requirements.

WALL PROTECTION IS DISCUSSED IN FURTHER DETAIL ON PAGE 12 OF THIS MANUAL.

MANTEL CLEARANCES

	A
C	B
D

A = Top to Mantel	34”	860mm
B = Top to Top Trim	20”	510mm
C = Side to Side Trim	13”	330mm
D = Side to Side Wall:	24’	610mm

11