Slot Combinations

Appendix B

This appendix lists the IOA slot combinations and contains the following sections:

■IOA Slot Combinations on page 63

IOA Slot Combinations

Depending on the software release and IOA type, you must install IOAs in certain slots and bays combined with other IOAs in the same slot:

■You must insert some IOAs only in the upper bay (Adapter 0) of each IOA module slot. If you insert one of these IOAs into a lower bay slot, the line module diagnostics fail, an error message states that the bottom slot is not supported for the currently installed software release, and the slot is disabled.

■If you insert an unrecognized IOA, such as an IOA that is not supported by a particular software release, the line module diagnostics fail, an error is generated, and the slot is disabled.

■If you remove an IOA and replace it with a different IOA in the same slot, an error message states the mismatch and the slot is disabled.

■Full-height IOAs take up the entire slot (both Adapter 0 and Adapter 1).

For information about working with modules and IOAs, see JUNOSe System Basics Configuration Guide, Chapter 6, Managing Modules. See Table 22 on page 63 for currently available IOAs and the bays in which you may insert them.

Table 22: E320 IOA Locations and Combinations

IOA	Upper Bay (Adapter	Lower Bay (Adapter	Both Bays	Combined with Other
	0)	1)	Concurrently	IOAs in Same Slot
ES2-S1 GE-4	Yes	Yes	No	No
ES2-S1 GE-8	Yes	Yes	Yes	Yes (GE-8 when
				paired with ES2 4G
				LM or ES2 10G LM;
				GE-8, OC3/STM1, and
				OC12/STM4 IOAs
				when paired with ES2
				4G LM)

IOA Slot Combinations ■ 63

Juniper Networks manual Slot Combinations, E320 IOA Locations and Combinations

Models: E320