Installation of CLARIS plus filter cartridges

5. Installation of CLARIS plus filter cartridges

If the CLARIS plus filter cartridge is installed properly, de- scaling of the coffee machine is no longer required. For more information on the CLARIS plus filter cartridge refer to brochure «CLARIS plus. Hard on limescale. Gentle on your coffee machine.»

5.1 Installing the filter

Fold up the cartridge holder. Install the filter cartridge in the water tank, applying a gentle pressure (Fig. 1).

Fold down the cartridge holder again until it engages audibly.

Fill the water tank with cold, fresh tap water and install it again.

Press the programming key (4), the illuminated ring (2) is active.

FILTER

Press the Rotary Switch (1) to start the programming.

NO –

Turn the Rotary Switch (1) until the following message is dis- played:

YES

Press the Rotary Switch (1) to activate the filter cartridge.

INSERT

OPEN TAP

Put a sufficiently large container (at least 0.5 litre) under the Easy-Auto-Cappuccino Frother (15) (Fig. 10).

If not installed already, insert the CLARIS plus filter.

Open the steam / hot water draw-off tap (14) (Fig.13).

RINSING

FILTER

CLOSE TAP

Close the steam/hot water draw-off tap (14), now the IM- PRESSA will heat up to coffee temperature.

HEATING

READY

	Now you have activated the filter. In Programming Mode the	E


	water hardness selection function is no longer displayed.
	water hardness selection function is no longer displayed.
5.2 Replacing the filter
	After drawing off approx. 50 litres, the filter cartridge will be


	used up. A message requesting you to replace the filter will


	appear on the display. Please monitor the period of use of the
	CLARIS plus filter cartridge (max. 2 months) using the scale
	on the cartridge holder by the water tank.