- 26 -
Manual Search:
This is for searching for digital channels on
a single broadcast frequency. The frequency
channel number (21-68) is entered in the
box at the top left of the screen and the re-
ceived signal level and signal quality can be
observed on the two bar graphs at the bot-
tom. When OK is pressed, the TV searches
that frequency and display a list of the chan-
nels found.
Hint
The bar graphs of signal quality and signal
level give a good indication of whether any
channels are likely to be found. If only the
signal level graph shows a high value then
it is likely that an analogue channel occu-
pies that broadcast frequency. If the signal
quality bar is high as well then it is a digital
frequency and digital channels will prob-
ably be found.
Again, channels which duplicate those al-
ready in the channel list are ignored. How-
ever, the manual channel search will find all
channels on the broadcast frequency.
When either search is finished, press the
MENU key to return to normal broadcast
viewing, to watch the new digital terrestrial
television channels found.
First Time Installation:
To reset the TV, highlight the First Time In-
stallation line in the menu and press OK. A
warning screen is displayed in case of acci-
dental operation.
Highlight the YES button with the   or 
key and press OK to erase all the channels
and settings and switch the receiver to
standby.
Common Interface
It is required to subscribe to a pay channel
company to view the pay channels of the
Digital Terrestrial broadcasting.
Obtain the Conditional Access Module
(CAM) and the Viewing card by subscribing
to a pay channel company, then insert those
to the Television using the following proce-
dure.
1. Switch off the TV and unplug from the
mains.
2. Insert the CAM, then Viewing Card to the
slot that is located in the terminal cover at
the left-hand side of the TV (from front
view).
 The CAM should be correctly inserted, it is
impossible to insert fully if reversed. The
CAM or the TV terminal may be damaged if
the CAM is forcefully inserted.
3. Connect the TV to the mains supply,
switch on and then wait for few moments
until the card is activated.
 Some CAMs may require the following set
up. Please set the CAM by entering the DTV
menu, Common Interface then pressing OK
button. (CAM set up menu is not displayed
when it is not required.)
 To see the viewing contract information,
press MENU, Select DTV and Press OK ,
then Select Common Interface and press
OK.
 When no module is inserted, No CI Mod-
ule appears.
 Refer to the module instruction manual for
details of the settings.
ENG-IDTV-JVC-1724W-17 INCH TFT LCD.230205.p65 24.02.2005, 08:1926