JVC AX-V55BK manual Specifications, Amplifier, General, English

Specifications

Amplifier

Output Power	At Stereo Operation
	Front Channels	55 watts per channel, min. RMS, driven into 4 ohms at 1 kHz with
		no more than 0.9% total harmonic distortion. (IEC268-3/DIN)
		40 watts per channel, min. RMS, driven into 8 ohms at 1 kHz with
		no more than 0.9% total harmonic distortion. (IEC268-3/DIN)
		40 watts per channel, min. RMS, driven into 8 ohms, 40 Hz to 20
		kHz with no more than 0.8% total harmonic distortion.
	At Surround Operation
	Front Channels	50 watts per channel, min. RMS, driven into 8 ohms at 1 kHz with
		no more than 0.8% total harmonic distortion.
	Center Channel	50 watts, min. RMS, driven into 8 ohms at 1 kHz, with no more
		than 0.8% total harmonic distortion.
	Rear Channels	50 watts per channel, min. RMS, driven into 8 ohms at 1kHz, with
		no more than 0.8% total harmonic distortion.
Total Harmonic Distortion		0.8 %* at 40 watts output
(8 ohms, 1 kHz)		(* Measured by JVC Audio Analysis System)
Frequency Response (8 ohms)	PHONO	20 Hz to 20 kHz (±1 dB)
	TUNER, CD, TAPE, VCR, VIDEO	20 Hz to 20 kHz (±1 dB)
Audio Input Sensitivity/	PHONO (MM)	2.5 mV/47 k ohms
Impedance (1 kHz)	TUNER, CD, TAPE, VCR, VIDEO	200 mV/47 k ohms
Audio Output Level	TAPE, VCR	200 mV
Signal-to-Noise Ratio	PHONO	70 dB/66 dB
(’66 IHF/DIN)	TUNER, CD, TAPE, VCR, VIDEO	87 dB/67 dB
RIAA Phono Equalization		±0.5 dB (20 Hz to 20 kHz)
Loudness		+5 ± 2 dB at 100 Hz
(Volume Control at –40 dB)
Video Input Sensitivity/	VCR, VIDEO	1 Vp-p/75 ohms
Impedance
Video Output Level	VCR, MONITOR OUT	1 Vp-p (at 1 Vp-p input)
Synchronization		negative
Signal-to-Noise Ratio		45 dB

General

Power Requirements	AC 230V , 50 Hz
Power Consumption	240 watts
	2 watts (in standby mode)
Dimensions (W x H x D)	435 x 146 x 403 mm
	(17 3/16 x 5 3/4 x 15 7/8 inches)
Mass	8.0 kg (17.7 lbs)
	Design & specifications are subject to change without notice

English

Page 28